INV=INPUT_NOT_INVERTED_, FUNC=PIO0_26, OD=DISABLE_, SLEW=SLOW, MODE=INACTIVE_NO_PULL_DO, HYS=DISABLE_
I/O configuration register for pin PIO0_26/TXD/MISO1/ CT16B1_CAP1/ CT32B0_CAP2
| FUNC | Selects pin function for pin PIO0_26/TXD/MISO1/ CT16B1_CAP1/ CT32B0_CAP2 0 (PIO0_26): General purpose digital input/output pin. 1 (TXD): Transmitter data output for USART. 2 (MISO1): Master In Slave Out for SSP1. 3 (CT16B1_CAP1): Capture input 1 for 16-bit timer 1. 4 (CT32B0_CAP2): Capture input 2 for 32-bit timer 0. |
| MODE | Selects function mode (on-chip pull-up/pull-down resistor control). 0 (INACTIVE_NO_PULL_DO): Inactive (no pull-down/pull-up resistor enabled). 1 (PULL_DOWN_RESISTOR_E): Pull-down resistor enabled. 2 (PULL_UP_RESISTOR_ENA): Pull-up resistor enabled. 3 (REPEATER_MODE_): Repeater mode. |
| HYS | Hysteresis. 0 (DISABLE_): Disable. 1 (ENABLE_): Enable. |
| INV | Invert input 0 (INPUT_NOT_INVERTED_): Input not inverted (HIGH on pin reads as 1, LOW on pin reads as 0). 1 (INPUT_INVERTED_HIGH): Input inverted (HIGH on pin reads as 0, LOW on pin reads as 1). |
| RESERVED | Reserved. |
| SLEW | Driver slew rate 0 (SLOW): Slow. More outputs can be switched simultaneously. 1 (FAST): Fast. |
| OD | Open-drain mode. 0 (DISABLE_): Disable. 1 (OPEN_DRAIN_MODE_ENAB): Open-drain mode enabled. This is not a true open-drain mode. Input cannot be pulled up above VDD. |
| RESERVED | Reserved. |